TM 9-2330-275-14&P
4-64. FRONT SUSPENSION BAR MAINTENANCE (M832 SN J089-001 THRU 159 AND J017-
160 THRU 350 ONLY).
This Task Covers:
a. Removal
c. Installation
b. Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts
Front and rear dollies uncoupled (pars 2-11),
six locknuts
Air reservoir removed (pars 4-43).
Eight cotter pins
Reflectors removed (pars 4-72).
One stud
Data plates removed (pars 4-73).
Six resilient mounts
Dolly caster assemblies removed, if necessary
Seven sleeve bushings
(para 2-10).
Two threaded rods
Four Iockwashers
Tools/Test Equipment:
Personnel Required:
General mechanic’s tool kit
Common no. 1 shop set
Fabricated spacers
Two
NOTE
If suspension bar for this model
requires caster mounts, see
Appendix G for front suspension
bar modification instructions.
a
REMOVAL
1.
Remove two screws (10) and Iockwashers
(8) from two wire rope assemblies (9).
Discard Iockwashers.
2.
Remove two screws (5), Iockwashers (7),
and wire rope assemblies (6) from
suspension bar (4). Discard Iockwashers.
3.
Remove two screws (3), retaining straps
(2), and webbing straps (1) from suspension
bar (4).
4-167
