TM 55-4920-376-14&P
C1
b.
Scrape off loosened surfacing with a scratch brush.
c.
Repeat Steps a and b, as necessary until all finish
has been removed.
Prime with TT-P-636 alkyd primer. Finish with a mix
d.
of TT-E-529 alkyd enamel and Reardon ADMIX in the
proportions recommended in the ADMIX package.
Allow 4 to 8 hours to dry.
SHELTER FLOOR PANEL REPLACEMENT
4.9
The shelter floor is 3/8" plywood covered with .020 inch
thick aluminum. To replace a defective or damaged floor, proceed
as follows:
Remove the old
a.
Drill out all the rivets in the flooring.
flooring.
b.
Obtain a replacement Frame Floor Panel, P/N AA4920-7016-
27-5 (60, Fig. 8).
c.
Using the old floor panel as a template, duplicate the
required No. 8(.199) diameter holes in the new floor panel.
Apply GE Silicone construction sealant SE1202, per Federal
d.
Specification TT-S-230 in a 1/16" bead on the below-floor
framework.
e.
Using 1/4 inch sheetmetal screws, fasten the new flooring
in place.
f.
Refinish as instructed in paragraph 4.8.
4.10
TENTAGE REPAIR
If in need of repair, the tenting can be patched by the
following procedure:
a.
Using a piece of material per MIL-C-20696 Type 2 in an
appropriate color, cut out a patch 1 inch wider on all
sides than the tear to be mended.
b.
Apply 3M Compound EC 971 Industrial Adhesive (NSN 8040-
13
