ARMY TM 10-8340-224-13AIR FORCE TO 35E5-6-1NAVY NAVFAC-P-337.A2-25. DECALS AND INSTRUCTION PLATES (CONT) .STEP-6AFTER THE END WALLS AND ROOF SECTIONS ARE IN PLACE AND SECURED WEWILL PLACE AND SECURE THE EXTENDER IN THEIR RESPECTIVE PLACES.PLACE EXTENDERS OVER PIN PROTRUDING FROM FRAME. ALIGN HOLE INEXTENDER WITH HOLE IN PIN AND LOCK IN PLACE WITH SECURING CLIP.USE ONE 19’ GUY LINE ON EAVE EXTENDERS AND TWO 19’ GUY LINES ONRIDGE EXTENDERS. PASS SEWN END OF GUY LINE AROUND RIDGE OR EAVEEXTENDERS AND THRUEYE SPLICE AS SHOWN ABOVE. AFTER GUY LINES AREIN PLACE, PASS SEWN END OF GUY LINES THRU BOTH HOLES IN TENTSLIPS AND PLACE KNOT IN SEWN ENDS.STEP-7PLACE FLY ON EXTENDERS STARTING AT THE RIDGE. PLACE GROMMET OVERPIN AND LOCK IN PLACE (SECURING CLIP ATTACHED TO FLY) WITH CLIPTHRUHOLE IN PIN. REPEAT THIS SEQUENCE TO SECURE FLY TO EAVEEXTENDERS.(ALL EAVE EXTENDERS HAVE TWO (2) SECURING CLIPSATTACHED) . ALL EAVE EXTENDERS SHOULD HAVE GUYLINES.STEP-8WHEN THE ROOF SECTIONS, ENDWALLS, FLY, AND GUYLINESARE SECUREDIN PLACE WE CAN NOW RAISE THE TENT. PLACE TWO PEOPLE AT EACH ARCHSECTION AT THE EAVE LOCATION. THE NCO IN CHARGE SHOULD MAKECERTAIN THAT THE FRAME IS RAISED EVENLY AND SIMULTANEOUSLY ATEACH ARCH. ON HIS COMMAND RAISE THE SHELTER (AT EAVE LINE) ANDSWING THE LOWER LEG OF THE FRAME INTO.PLACE, THEN SECURE IN PLACEWITH PIN. NOTE: THE PERSONNEL AT EACH END OF THE SHELTER SHOULDMAKE CERTAIN THAT THE FABRIC DOES NOT GET CAUGHT IN THE FRAMEHINGE .STEP-9WE CAN NOW FINISH CLOSING THE TENT BY ENGAGING THE LOOPS ANDSECURING THEM. WHEN TENT IS IN THIS POSITION - CHECK SCREEN FLAPLINES AND GUYLINES TO MAKE CERTAIN THEY ARE FREE TO OPERATE.STEP-10WE NOW RAISE THE OPPOSITE SIDE IN THE SAME MANNER. FINISH CLOSINGTHE TENT.Figure 2-5.ABBREVIATED SET UP INSTRUCTIONS (CONT)2-64
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
