INSTALL DOUBLE BUMP-THROUGH DOORS IN END SECTION

INSTALL DOUBLE BUMP-THROUGH DOORS IN VESTIBULE OR VESTIBULE ADAPTERINSTALL DOUBLE BUMP-THROUGH DOORS IN VESTIBULE OR VESTIBULE ADAPTER (cont)

INSTALL DOUBLE BUMP-THROUGH DOORS IN END SECTION (CONT)

TM-10-8340-224-13 Tent Extendable Modular Personnel (Temper) Manual
Page Navigation
73

ARMY TM 10-8340-224-13 AIR FORCE TO 35E5-6-1 NAVY NAVFAC-P-337.A o. Close the weather flaps by sealing them around the double access door frame, if placed at end of vestibule. . P“ Tie guy lines (9) to stakes (11) and tighten. 2-21. INSTALL DOUBLE BUMP-THROUGH DOORS IN END SECTION. Proceed with the following to install doors in end section doorway. a. Unzip, roll up, and tie the end section fabric door (1) . b. Disconnect the hook and pile fastener holding the screening (2) and liner door (3) in place. c . Roll up and tie the screen (2) . d. Roll up and tie the liner door (3) . e . Stand the double bump-through door (1) up and lock the doors in the closed position. f. Loosen the set screw (5) on top of the doors. 2-55

Privacy Statement
Press Release
Contact