INSTALL DOUBLE BUMP-THROUGH DOORS IN VESTIBULE OR VESTIBULE ADAPTERINSTALL DOUBLE BUMP-THROUGH DOORS IN VESTIBULE OR VESTIBULE ADAPTER (cont)

INSTALL DOUBLE BUMP-THROUGH DOORS IN VESTIBULE OR VESTIBULE ADAPTERINSTALL DOUBLE BUMP-THROUGH DOORS IN VESTIBULE OR VESTIBULE ADAPTER

INSTALL DOUBLE BUMP-THROUGH DOORS IN END SECTION

TM-10-8340-224-13 Tent Extendable Modular Personnel (Temper) Manual
Page Navigation
72

ARMY TM 10-8340-224-13 AIR FORCE TO 35E5-6-1 NAVY NAVFAC-P-3’37.A 2-20. INSTALL ADAPTER (CONT) c. d. e. f. 9. h. i. j. k. 1. m. n. Remove Remove Insert DOUBLE BUMP-THROUGH DOORS IN VESTIBULE OR VESTIBULE . the door extenders (3) . NOTE To store the door extenders, place them in either side of the doorway between the liner and the endwall or in a foot locker. the arch (4) from the vestibule frame. the post of the arch (4) in holes on each side of the top of the double bump-through doors. Tighten the set screws (2). Identify the triangular vestibule arch cap (5) . Place the cap grommets (6) over the arch (4) spindles. Press the hook fastener of the arch cap to the pile fastener of the door frame. CAUTION Lift door ramps prior to placing weight on door frame. Damage to piano hinge may result. Place the double bump–through door into position. Place the vestibule adapter and vestibule grommets (7) over the arch (4) spindles. NOTE Place the knot on one side or the other side of the frame so it does not interfere with the movement of the doors. Move the door (1) to a vertical position. Tie the tie tapes (8) to the frame of the door. Install two guy lines (9) under hitch clip pins (10) on arch spindles, if placed at end of vestibule. 2-54

Privacy Statement
Press Release
Contact