TM 10-8340-205-13&P
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
PAGE
Section I
Lubrication Instructions.................................................................................................. 3-1
Section II
Operator Troubleshooting Procedures ........................................................................... 3-1
3.1
Introduction ................................................................................................................... 3-1
3.2
Troubleshooting............................................................................................................. 3-1
Section III
Operator's Maintenance Procedures .............................................................................. 3-4
3.3
General ......................................................................................................................... 3-4
SECTION I. LUBRICATION INSTRUCTIONS
Lubrication is not required.
SECTION II. OPERATOR TROUBLESHOOTING PROCEDURES
3.1 INTRODUCTION .
a. This table lists common malfunctions that you may find with your equipment. Perform the inspections
and corrective actions in the order they appear in the table.
b. This table cannot list all the malfunctions that may occur, all the inspections needed to find the fault, or
all of the corrective actions needed to correct the fault. If the equipment malfunction is not listed or actions not
listed to correct the fault, notify your supervisor.
3.2 TROUBLESHOOTING .
Troubleshooting procedures are provided in Table 3-1. Notify Unit Maintenance for other malfunctions
observed.
3-1
