TM 10-7360-211-13&P
4-2 Change 7
Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT
4-1. COMMON TOOLS AND EQUIPMENT. Refer to your unit's Modified Table of Organization and Equipment, (MTOE) to
determine the common tools and equipment authorized and available at your unit.
4-2. SPECIAL TOOLS, TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT.
The special tools required to maintain the FSC are listed in Appendix F, and Section III, Appendix B. No TMDE, or special
support equipment is required at the unit level to maintain the FSC.
4-3. REPAIR PARTS. Repair parts authorized for unit maintenance are listed in Appendix F.
Section II. SERVICE UPON RECEIPT
4-4. UNPACKING. The FSC, with components, will be packaged in wooden crates strapped to wooden pallets. Check crates
for indication of damage. Report any damage to your supervisor.
CAUTION
Unpack components carefully. Improper or hasty handling may result in damage to the
FSC components and accessories.
a. Procedure. Unpack the equipment in the following sequence:
(1) Position crate or carton to be unpacked with the top facing up.
(2) Cut and remove retaining straps. Do not cut, rip, or otherwise damage packing material.
(3) Open the carton, remove the corrugated padding material, and set it aside.
(4) Lift the equipment from the carton.
b. Shipping Material. Save the shipping carton and padding material so it can be re-used.
4-5. CHECKING UNPACKED EQUIPMENT.
a. Damage. Inspect the equipment for damage incurred during shipment. Report any damage on SF Form 364, Report
of Discrepancy. Also note damage on DA Form 2404, Equipment Inspection and Maintenance Worksheet and initiate
corrective maintenance procedures.
b. Completeness. Check equipment against the packing slip to see if the shipment is complete. Report all discrepancies
on SF Form 364. The equipment can be placed in service even though a minor assembly or part, which does not affect
proper functioning, is missing.
c. Modifications. Check DA PAM 25-30 to see if there is any Modification Work Order applicable to the FSC
components you are unpacking. If an MWO is listed, check to see if it has been applied to the equipment. The MWO number
will be shown on the case near the equipment nomenclature. If a current MWO is listed in DA PAM 25-30 but there is no
evidence that it has been applied to the equipment you are unpacking, note discrepancy on DA Form 2404, Equipment
Inspection and Maintenance Worksheet.