TM 10-7360-211-13&P2-212-8.DISASSEMBLY AND PREPARATION FOR MOVEMENT (CONTD).(1) Sink Assemblies.(a) Place the burner unit of each sink assembly into the burner rack.(b) Place the base rack, with the bottom facing down, over the burner rack.(c) Place this assembly Into the sink body assembly.(d) Wrap the thermometer and it's bracket In barrier material (Item 1. Appendix E) and place on top of theburner units.(e) Place the sink cover on the sink body assembly.(2) Storage Rack Assembly (Two-piece Set No. 1).(a) Place the single sink drain hose assembly (1) into one waste receptacle (2) and cover with lid (3).(b) Place two gasoline lanterns (4), in cartons or barrier material (Item 1, Appendix E), into one immersion rack(5).(c) Place the nested waste receptacle and nested immersion rack into one storage rack assembly (6).(d) Position another empty storage rack assembly (7) close to the packaged one.(e) Install as low as possible, two shelves (8) into the empty storage rack assembly (7).WARNINGSerious injury could occur if heavy equipment is moved/lifted withoutsufficient personnel to do the Job. Use proper physical liltingprocedures or use a suitable lifting device or dolly. Wear safety shoes,gloves and other suitable protective clothing.(f) Use two-man lift (one man each end), carefully rotate the two-shelved storage rack (7) and (8). Thebottom is now top.(g) Position each of the storage rack assemblies so that each of its empty sides face each other.(h) Slide each storage rack assembly together to form a box.(3) Storage Rack Assembly (Two-Piece Set No. 2)(a) Perform same procedure as in paragraph 2-8b(2), packaging three sink drain assembly into wastereceptacle, and fire extinguisher In carton or barrier material (item 1, Appendix E) into one immersion rack.(4) Storage Rack Assembly (Two-Piece Set No. 3).Perform same procedure as in paragraph 2-8b(2), packaging miscellaneous equipment.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
