TM 10-7360-209-13&P
5-3.
RIVET REPLACEMENT (Continued)
(b) Place drill in center-punched mark. When using a power
drill, rotate the bit a few turns by hand before starting motor. While drilling,
always hold drill at a 90-degree angle to work.
(c) Avoid excessive pressure; let the drill do the cutting.
Never push drill through stock.
Remove all burrs with a metal countersink or
f i l e .
(d) Transfer holes from a drilled part to another part by placing
second part over first and using established holes as a guide.
5-4. WELDING.
KCLFF major components, such as the Heater Tank Assembly, Cooking
Pot Cradle Assembly, and Table Assembly may require repair by welding. Refer
to TM 9-237 for information on welding theory and application.
5-3/(5-4 Blank)
