TM 10-7360-208-13&P
2-12. OPERATION UNDER RAINY OR HUMID CONDITIONS.
a.
When not in the tent, M2 burner units must be covered with canvas or other waterproof material. Remove the
cover during dry periods, expose to open air, and allow units to dry.
b.
Operate the M2 burner units under rainy or humid conditions in accordance with TM 10-7360-204-13&P.
2-13. OPERATION IN SALT WATER AREAS.
a.
Keep equipment from contact with salt Water whenever possible. If contact is made, or if equipment is exposed
to salt spray, wash equipment frequently with clean fresh water.
b.
Operate the M2 burner units in salt water areas in accordance with TM 10-7360-204-13&P.
2-14. OPERATION AT HIGH ALTITUDES.
Operate the M2 burner units at high altitudes in accordance with TM 10-7360-204-13&P.
2-15. OPERATION IN WINDY CONDITIONS.
a.
Whenever possible, take advantage of natural barriers to block the wind.
b.
Close the doors and windows of the tent on the windward side and open the tent on the leeward (downwind) side.
c.
Operate the M2 burner units in windy conditions in accordance with TM 10-7360-204-13&P.
2-16. OPERATION IN EXTREME HEAT.
WARNING
•
Extreme heat will cause tank pressure to increase because
of fuel expansion. Start with prescribed pressure in
accordance with TM 10-7360-204-13&P.
•
Check air pressure frequently during burner unit operation.
•
Operators be aware of signs of heat stress. Use maximum
ventilation. All windows, doors, and roof vents should be
opened.
a.
Operate the M2 burner units in extreme heat in accordance with TM 10-7360-204-13&P.
b.
The tent should have maximum ventilation. All windows, doors, and roof vents should be opened.
2-17. OPERATION IN DUSTY OR SANDY AREAS.
a.
Take advantage of any natural barriers that may be available when selecting the site.
b.
Where water is available, keep the immediate area wetted down. Keep all equipment as clean as possible.
c.
Keep dirt and grit out of the M2 burner unit fuel system and reserve fuel supply.
d.
Operate the M2 burner in dusty or sandy areas in accordance with TM 10-7360-204-13&P.
2-61/(2-62 blank)
