TM 10-7360-208-13&P
4-18. REPAIR OF INSULATED LIQUID DISPENSER (CONT).
d. Faucet Assembly and Spout Assembly.
REMOVAL
1.
Loosen cap (6) from top of faucet (8) and remove silicone rubber seat cup (7).
2.
Loosen wing nut (4) and remove faucet (8) from spout (1).
3.
Remove C nut (5) and wing nut (4) from spout (1).
4.
Remove hex nut (3), spout (1) and preformed packing (2).
REPLACE
1.
Install spout (1) and preformed packing (2) from the inside through dispenser wall. Ensure gasket (9) is in place.
2.
Replace hex nut (3) and tighten.
3.
Install wing nut (4) and C nut (5) on spout (1).
4.
Install silicone rubber seal cup (7) and install cap (6) on faucet (8) and tighten.
5.
Install faucet (8) to spout (1) and tighten wing nut (4).
4-18
