TM 10-7310-281-13&P
MODERN BURNER UNIT (MBU)
0005 00
OPERATION UNDER USUAL CONDITIONS
0005 00-6
Place the retaining bar (4) through the handle of the power converter (6) and over the two mounting
bracket shafts (5). Be sure to keep the bar level while sliding over the shafts to prevent binding. Install
the two wing nuts (3).
Power Converter Mounting Bracket With Power Converter Installed
Connecting Cables in the MKT. With the power converter in position on the mounting bracket, connect
the end of the Crossway Cable (1) extending up through the floor of the cooling cabinet to the lower
output connector (2) on the power converter (3).
Connect the main connector (4) of the 2 branch cable to the upper output connector (5) of the power
converter (3).
Connect the end of the Feedway Cable (6) extending up through the floor of the cooling cabinet to the
power cord (7) of the power converter (3).
Pass the remainder of the 2 branch cable through the left side of the cooling cabinet and distribute it
under the two M59 Field Ranges (8).
Pull the individual branch cables (9) out the front of each appliance and connect each branch to the
power-in receptacle (10) of each MBU.
Distribute a 4 branch cable (11) along the floor in front of the appliances (12) on the opposite side of the
MKT.
Connect the main connector (13) of the branch cable to the end of the Crossway Cable (14) extending up
through the floor of the MKT opposite the cooling cabinet.
Hang the 4 branch cable along the front of the appliances with cable clips (15) provided with the MBU.
1 (cutaway for clarity)
2
3
4
5
6
