TM 10-5411-224-14
5-10.
REPAIR OF SHELTER DOOR DRIP MOLDING.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Tools:
Drill (Item 4, Appendix B)
#11 Drill Bit (P/O Item 4, Appendix B)
Safety Glasses (Item 8, Appendix B)
Riveting Tool (Item 3, Appendix B)
Materials/Parts:
Dome Head Pop Rivets (Item 18, Appendix E)
Drip Molding
REMOVAL
WARNING
Drilling creates metal chips which may enter eyes and cause serious injury. Eye protection is required.
CAUTION
Make sure the drill bit has a drill stop attached to prevent the drill bit from exceeding a depth of one inch.
1.
Using a drill with a #11 drill bit, carefully drill out seven rivets (2) securing drip molding (1) to shelter.
2.
Remove drip molding (1).
INSTALLATION
1.
Locate drip molding (1) to shelter and insert seven rivets (2) through holes in drip molding (1) and into holes in
shelter.
2.
Using a pop rivet tool, secure drip molding (1) to shelter.
3.
Prime and paint repaired panel surface in accordance with Chapter 3, paragraph 3-7.
5-27
