REPAIR OF SHELTER PANEL DELAMINATION - continued

REPAIR OF SHELTER PANEL DELAMINATION - continued - TM-10-5411-224-14_81

REPAIR OF SHELTER PANEL DELAMINATION - continued - TM-10-5411-224-14_83

TM-10-5411-224-14 Lightweight Multipurpose Shelters (LMS) Model No. S-78B/G Type I and Type III & 5411-01-357-3683 Manual
Page Navigation
73

TM 10-5411-224-14 5-9. REPAIR OF SHELTER PANEL DELAMINATION - continued. WARNING To avoid injury to personnel, safety glasses must be worn during drilling and sanding operations. CAUTION Make sure the drill bit has a drill stop attached to prevent the drill bit from exceeding a depth of 5/8 inch. 2. Using a drill with a #11 drill bit, drill clearance holes (number of holes is dependent on the size of the 0delamination) for 3/16 inch pop rivets spaced (not greater than 5 inches on center) within the chalk line. 3. Using the outline of the marked delaminated area, mask the surrounding area approximately two feet wide with polyethylene. WARNING To avoid injury to personnel, gloves must be worn when working with adhesive. 4. In a clean unwaxed container, mix Epic R1002 adhesive with Versamid 140 material as follows: By Weight: 15 oz. Epic to 5 oz. Versamid By Volume: 2 parts Epic to 1 part Versamid NOTE The mixed adhesive must be used within the time specified below, considering the ambient temperature. 60° F - 2 hours 70 F- 1 hour 80 F - 40 minutes 90 F - 20 minutes 5-25

Privacy Statement
Press Release
Contact