TM 10-5411-201-14
T.O. 35E4-178-1
CHAPTER 4
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I.
REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
4-1.
COMMON TOOLS AND EQUIPMENT.
a.
Appendix B, Section III contains the authorized common tools.
b.
For authorized equipment refer to Modified Table of Organization and
Equipment (MTOE) applicable to your unit.
4-2.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
a.
A special tool, hand blind riveter, Appendix B, Item 2 is used for
shelter skin repair and general riveting utilizing blind rivets.
b.
Installation tools, Appendix B, Items 3 and 9 are used for
installation of captive screws.
c.
Portable electric router, Appendix B, Item 15 is used to cut out
panels.
Use tripod base heat lamp, Appendix B, Item 16 during panel repair.
d.
Snap ring pliers, Appendix B, Item 10, is used to remove and install
retaining rings on closeout panels.
e.
Fastener header, Appendix B, Item 7 or 8 and box end or adjustable
wrench, Appendix B, Item 11 are used to install non-potted inserts.
f.
Multimeter, Appendix B, Item 4, is used to perform all
continuity/voltage tests on shelter.
Electric tool kit, Appendix B, Item 5 is
used to repair wiring.
g.
Use portable electric drill, Appendix B, Item 6 to drive hinge pins.
h.
Blind bolt removal tool kit, Appendix B, Item 13, is used to remove
rivets on hinge edge members of floor panel.
i.
Installation tool, Appendix B, Item 14 is used to install. rivets on
hinge edge members of floor panel.
j.
Use crimping tool, Appendix B, Item 12, to attach wires to
receptacle pins on power entry panel.
4-3.
REPAIR PARTS.
Repair parts covering organizational maintenance for this
shelter are listed and illustrated in TM 10-5411-201-24P.
4-1