TM 10-5411-201-14T.O. 35E4-178-14-32.(cont)NOTEDrying time will vary and is determined by experienceand amount of moisture in panel.Core material willfeel hard and brittle when dry,d.After core material is thoroughly dried, repair panel in accordancewith the applicable repair task.4-33.BLIND RIVET REMOVAL AND INSTALLATION.a.Remove blind rivets as follows:WARNINGWear safety goggles for eye protection from flyingmetal chips.(1) Select drill bit the same diameter asinstalled blind rivet.(2) Install selected drill bit in hand drillchuck.(3) Hold drill perpendicular to the surface toprevent enlargement or damage to existing hole.(4) Drill through center of rivet just deepenough to sever rivet head from shank.(5) Remove remainder of rivet with a pinpunch.(6) Deburr rivet hole.b.Install blind rivets as follows:(1) Select proper diameter and length ofblind rivet (Items 13-16, Appendix E).(2) Select appropriate nose piece for handblind riveter and install nose piece.(3) Wet rivet with sealant (Item, 18, AppendixE and insert rivet in hole.4-154
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
