EQUIPMENT CONTAINER REPLACEMENT AND REPAIR (cont)

EQUIPMENT CONTAINER REPLACEMENT AND REPAIR - TM-10-5411-201-14_234

TM-10-5411-201-14 Shelter Tactical Expandable One-Sided NSN 5411-01-124-1377 60 AMP Model NSN 5411-01-295-3433 100 AMP Model Manual
Page Navigation
216

TM 10-5411-201-14 T.O. 35E4-178-1 4-31. (cont) 3. Inspect for and replace if necessary: a. Missing or damaged components. Corrosion or paint damage. R E P A I R 1. Corrosion or paint damage (Refer to paragraph 4-44) 2. Replace damaged tie-down ring or strap assembly. INSTALLATION 1. 2. 3. 4. 5. 6. Position draw pull catches (11) on equipment container (3) and secure with rivets (10). (Refer to paragraph 4-33) Position safety hasp (9) on equipment container (3) and secure with rivets (8). (Refer to paragraph 4-33) Position hinges (7) on equipment container (3) and secure with rivets (6). (Refer to paragraph 4-33) Position chest handles (5) on equipment container (3) and secure with rivets (4). (Refer to paragraph 4-33) Position equipment container (3) on floor panel. Install two tie-down rings (1) at the end of two strap assemblies (2) in holes in floor panel. to secure equipment container (3) to floor. NOTE The procedures in paragraphs 4-31 through 4-43 are typical and apply for all panel surfaces. 4-32. DRYING WATER-SOAKED AREAS IN PANELS. a. Care shall be taken to prevent water from entering panel core material, since it is very difficult to remove. When damage occurs, the punctured panel skin shall be temporarily protected to prevent entry of water until repair can be made. If water has been allowed to enter panel, the care material shall be dried prior to skin repair. b. Position heat lamps around damaged area. Adjust lamps so that panel surface temperature does not exceed 200°F (93.3°C). c. Allow heat lamps to remain in position until core material surrounding damaged area is thoroughly dry. 4-153

Privacy Statement
Press Release
Contact