HINGED PANEL LEVELING JACK ASSEMBLY SERVICE AND REPAIR (cont)

HINGED PANEL LEVELING JACK ASSEMBLY SERVICE AND REPAIR

HINGED PANEL LEVELING JACK ASSEMBLY SERVICE AND REPAIR (cont) - TM-10-5411-201-14_163

TM-10-5411-201-14 Shelter Tactical Expandable One-Sided NSN 5411-01-124-1377 60 AMP Model NSN 5411-01-295-3433 100 AMP Model Manual
Page Navigation
143

TM 10-5411-201-14 T.O. 35E4-178-1 4-19. (cont) 3. Inspect for and replace if necessary: a. Missing or damaged components b. Corrosion or paint damage. R E P A IR Corrosion or paint damage. (Refer to paragraph 4-44) LUBRICATION Lubricate jack assembly with grease. ASSEMBLY Jack Extension 1. Install lanyard (26), washer (28), and screw (27). 2. Install inside tube (24) in outside tube (25) and secure with quick-disconnect pins (23). Jack Assembly 3. 4. 5. 6. 7. 8. 9. Install jack screw (19) in inside tube (18). Align hole in jack screw (19) with access hole in inside tube (18) and install pin (22). Pack bearing (21) with grease and place on jack screw (19). Install inside tube (18) in outside tube (20). Position spring tension clip (12) on outside tube (20) and install screws (11). Assemble O-rings (29) on handle (5). Position handle (5) in support (6) and on jack screw (19) with holes in handle yoke and jack screw aligned. Install pins (3 and 4). 4-80

Privacy Statement
Press Release
Contact