TM 10-5411-200-14
T.O. 35E4-177-1
4-7. (cont)
NOTE
Do not use water to clean circuit breaker panel
assembly.
2.
Inspect mounting surfaces for corrosion and damage.
3.
Inspect for damaged circuit breakers or light switches.
4.
Inspect panel wiring for cracks, tears, burns, or other damage.
REPAIR
1.
Replace damaged circuit breakers or light switches.
2. Repair or replace damaged wiring.
INSTALLATION
Circuit B
.
reaker
Install circuit breakers (17 through 22) in circuit breaker box (8).
Connect wires (10) to circuit breakers (17 through 22).
Light Switches
3.
Position two light switches (16) in circuit breaker box (8) and secure
with four screws (13), nuts (14), and lockwashers (15).
4. Position two switch covers (12) over light switches (16) and secure
with four screws (11).
5. Connect wires (10) to light switches (16).
6. Attach panelboard (5) to circuit breaker box (8) with screws (6) and
washers (7).
7.
Place panel cover (4) on model NQOB panelboard (5), move clamp fingers
(3) to LOCK position and tighten captive screws (2).
8. Close circuit breaker panel door (l).
CHANGE 2
4-11
