TM 10-5411-200-14
T.O. 35E4-177-1
4-16. (cont)
9. Connect wires from left side roof beam (23) to each of three fixed roof
area ceiling lights (26). (Refer to paragrapg 4-46.)
10. Attach three fixed roof area ceiling light covers (25) to three fixed
area ceiling lights (26) with nine screws (24).
11. Connect wires from left side roof beam (23) to junction box (3).
(Refer to paragraph 4-46)
12. Attach junction box cover (2) to junction box (3) by installing four
screws (1).
13. Connect wires from left side roof beam (23) to circuit breaker box
(19). (Refer to paragraph 4-46)
14. On both models,
circuit breaker
(21).
15. On model NQOB,
position panelboard (22) over circuit breakers in
box (19) and secure with four screws (20) and washers
install panel cover (18) on the circuit breaker
panelboard (22), move four clamp fingers (17) to the CLOSE position and
tighten captive screws (16).
16. Close circuit breaker panel door (15).
Right Side Roof Beam Wiring
1.
Position right side roof beam (4) against roof and install washers
(14), lockwashers (13), and bolts (12).
2. Connect conduit locknuts (11) between junction box (3) and right side
roof beam (4).
3.
Install three push bar assembly pins (10).
4.
Connect wires from right side roof beam (4) to rear of two receptacles
(8). (Refer to paragraph 4-46)
5.
Install two receptacles (8) in two outlet boxes (9) and secure with
four screws (7).
6. Attach receptacle cover (6) to outlet box (9) with screw (5) at each
end of right side roof beam (4).
7. Connect wires from right side roof beam (4) to junction box (3).
(Refer to paragraph 4-46)
8. Attach junction box cover (2) to junction box (3) by installing four
screws (l).
CHANGE 2
4-55
