TM 10-5410-230-13CHAPTER 2OPERATING INSTRUCTIONSSubjectPageSection I DESCRIPTION AND USE OF OPERATOR'S CONTROLS AND INDICATORS ........................................2-1Section II OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES(PMCS)...............................................................................................................................................................2-12-1. GENERAL ..................................................................................................................................................2-1Section III OPERATION UNDER USUAL CONDITIONS ..........................................................................................2-92-2 SITE SELECTION..............................................................................................................................................2-92-3 REMOVAL OF MCPS TENT WALL ...................................................................................................................2-92-4 INSTALLING M577 BOOT WALL TYPE I ..........................................................................................................2-102-5 INSTALLING THE RIGID WALL SHELTER BOOT WALL TYPE II.....................................................................2-142-6 INSTALLING THE S-250E BOOT WALL TYPE IV .............................................................................................2-192-7 REMOVING THE M577 BOOT WALL TYPE I....................................................................................................2-242-8 REMOVING THE RIGID WALL SHELTER BOOT WALL TYPE II ......................................................................2-262-9 REMOVING THE S-250E BOOT WALL TYPE IV ..............................................................................................2-292-10 PREPARATION FOR MOVEMENT..................................................................................................................2-31Section IV OPERATION UNDER UNUSUAL CONDITIONS.....................................................................................2-312-11 GENERAL........................................................................................................................................................2-31Section I. DESCRIPTION AND USE OF OPERATOR'S CONTROLS AND INDICATORSNot applicable.Section II. OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)2-1. GENERAL.Table 2-1, Preventive Maintenance Checks and Procedures for SICPS Boot Walls, has been providedso you can keep your equipment in good operating condition and ready for its primary mission.a.WarningsandCautions.Always observe Warnings and Cautions appearing in your PMCS table. Warningsand Cautions appear before applicable procedures. You must observe these Warnings and Cautions to prevent seriousinjury to yourself and others or prevent your equipment from being damaged.b.ExplanationofTableEntries.(1)Item Number Column.Numbers in this column are for reference. When completing DA Form 2404(Equipment Inspection and Maintenance Worksheet), include the item number for the check/service indicating a fault.Item numbers also appear in the order in which you must do the checks and services listed.(2)Interval Column.This column tells you when you must do the procedure in the procedure column. TheBEFORE procedures must be done before you operate or use the equipment for its intended mission. DURINGprocedures must be done during the time you are operating or using the equipment for its intended mission. AFTERprocedures must be done immediately after you have operated or used the equipment.(3)Location, Check/Service Column. This column provides the location and the item to be checked orserviced. The item location is underlined.2-1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business