TM
10-5410-223-14/1
5. WITH THE FABRIC ENCLOSURE PULLED TO BOTH ENDS OF THE ROOF
AND FLOOR USE THE PULL STRAP AND PULL ENCLOSURE ACROSS THE
TRACK TO END.
TS 016760
Figure 4-13. Fabric enclosure, removal (sheet 5 of 5 ).
b. Repair.
(2) Refer to figure 4-13 (sheet 4 of 5), and with
(1) Repair, of the fabric enclosure consists of
fabric enclosure threaded out ends of folding floor
minor patching using those instructions listed in
and folding roof, pull towards the shelter using the
paragraph 4-15 b., above.
pulling straps.
(2) Report major damage to Direct Support
(3) Refer to figure 4-13 (sheet 3 of 5), secure the
Maintenance.
fabric enclosure at both ends of shelter with
(3) Replace an irreparable fabric enclosure.
fasteners and catch assemblies. Remove any
c. Installation.
blocking material used under folding floor.
(1) Refer to figure 4-13 (sheet 5 of 5), place bead
(4) Refer to figure 4-13 (sheet 2 of 5), press the
of fabric enclosure in track at left corner of folding
side and end insulating panels on the interior side
roof; follow the same procedure and thread fabric
of the fabric enclosure.
enclosure onto folding floor, using pull straps, pull
NOTE
fabric fastener across to cover end of shelter.
Panels are secured with fabric fastener tape.
(5) Refer to figure 4-13 (sheet 1 of 5), and
NOTE
Temporarily raise and block folding floor at each end
insert lower end of support assembly into the deep
to aid the installation of fabric enclosure.
draw can of the folding floor. Depress the handle
on upper end of support assembly. Push support
CAUTION
assembly into place and release the handle forcing
Care should be taken so that no damage
the plug at the upper end into the deep draw can
occurs to the aluminum skin of the folding
of the folding roof.
floor.
4-54
