TM 10-5410-223-14/1
Section V. TROUBLESHOOTING
tions that may occur or all tests or inspections and
4-13. General
corrective actions. If a malfunction is not listed
a. This section contains troubleshooting or
(except when malfunction and cause are obvious) or
malfunction information and tests for locating and
is not corrected by listed corrective actions, you
correcting most of the troubles which may develop in
should notify direct support maintenance.
the multipurpose shelter. Each malfunction or
trouble symptom for an individual component or
4-14. Organizational Maintenance Troubleshooting
unit is followed by a list of tests or inspections
necessary for you to determine probable causes and
may find during the operation or maintenance of the
suggested corrective actions for you to remedy the
multipurpose shelter or its components. You should
malfunction.
perform the tests/inspections and corrective actions
b. This manual cannot list all possible malfunc-
in the order listed.
Table 4-2. Troubleshooting
Malfunction
Test or Inspection
Corrective Action
1. WATER LEAKAGE INTO MULTIPURPOSE SHELTER
Check for damaged, loose, or improperly positioned weather seal assemblies.
Replace damaged or improperly positioned weather seal assemblies as follows:
Refer to paragraph 4-19 and remove rivets (1, fig. 4-8, sheet 1 of 3), retaining strips (2), and seals (3 and
4).
Remove rivets (5, fig. 4-8, sheet 2 of 3), strips (6) and seals (7).
Remove bolts (8, fig. 4-8, sheet 3 of 3), washers (9), and drain cap assembly (10).
Disassemble drain cap assembly by removing rivets (11) and freeing caps (12) and spacers (13, 14, and
15).
Remove seals (16).
Remove rivets (17 and 20), retaining straps (18 and 21), and seals (19 and 22). Remove rivets (23), plate
(24), and seal (25).
4-37
