TM 10-5410-221-14/1
(3) Press cover (42) on terminal board (45).
NOTE
Mark or otherwise identify electrical
leads for ease at installation.
6-43. Terminal Board (68, Fig. 6-7, Sheet 2 of 5)
(3) Remove nuts (66) and screws (67) which secure
NOTE
the termiboard (68) to the distribution box.
The following removal procedures apply
b. Installation. Using figure 6-7 as a guide, install
to shelter serial No. 1 thru 184 only.
terminal board as follows:
(1) Position terminal board (68, fig. 6-7, sheet 2 of
a. Removable. Remove terminal board (68, fig. 6-7,
5) in distribution box and secure with nuts (66) and
sheet 2 of 5) according to sequence of index numbers
screws (67).
assigned to figure 6-7 and observing the following.
(2) Replace electrical leads on proper terminals and
(1) Remove cover (65, fig. 6-7, sheet 2 of 5) from
secure with washers (71), lockwashers(70)and nuts (69).
terminal board (68).
(3) Press cover (65) firmly in place over terminal
(2) Remove nuts (69), lockwashers (70), and
board (68).
washers (71), and remove electrical leads from terminals
1 through 6.
Change 1 6-46
