TM 10-5410-22T-14/1
CHAPTER 2
OPERATING INSTRUCTIONS
Section I. OPERATING PROCEDURES
WARNING
If equipment fails to operate, refer
to
troubleshooting procedures in Chapter 3.
e. Hose Heater Receptacle. The hose heater
2-1. General
receptacle provides a source of 120/208 volts, 400 Hz
This section describes the various controls and utility
electrical power for connection of the hose heater.
connections and provides the operator/crew sufficient
f. Remote Temperature Se7.sor Receptacle. The
information to ensure connections and operation of the
remote temperature sensor receptacle provides for
expandable shelter.
connection of condition air source thermostat to the
remove temperature sensor. Used on shelter serial No.
2-2. Controls and Utility Connections
1 thru 184 only.
g. Telephone Jack. The telephone jack provides a
The controls and instruments are illustrated in
connection for an external telephone input line.
The location,
h. Drain Hose Heater Receptacle. The drain hose
description and purpose of each are given in the
heater receptacle provides a source of 120/208 volts.
following paragraphs.
400 Hz electrical power for connection of the drain hose
heater.
2-3. Power Input Panel
2-4. Power Output Panel
a. General. The power input panel (fig. 2-1) is
recessed on the lower outside of the front, center-
a. General. The power output panel (fig. 2-2) is
section wall. The power input panel provides power inlet
mounted on the rear center-section wall, adjacent to the
receptacles for 120/208 volts, 400 Hz; 120/240 volts, 60
shelter access door. The power output panel provides
Hz power, air lock light, hose heater, remote temperature
output receptacle for 120/208 volts, 400 Hz power;
sensor, telephone jack and drain hose heater.
120/240 volts, 60 Hz power, air lock light, and
b. 120/208 Volts, 400 HZ Power Inlet Receptacle.
emergency surgery light power supply inlet (fig. 2-2).
(1) The inlet receptacle is a five pin snap lock
b. 120/208 Volts, 400 Hz Power Output
receptacle with a hinged protective cover.
Receptacle.
(2) The inlet receptacle provides for connection
(1) The output power receptacle is a five pin
of a source of 120/208 volts, 400 Hz electrical power to
snap lock receptacle with a hinged protective cover.
the shelter electrical system.
(2) The outlet power receptacle provides for
c. 120/240 Volts, 60 Hz Power Inlet Receptacle.
connection of another shelter to the 120/240 volts, 60 Hz
(1) The inlet receptacle is a five pin snap lock
electrical circuit.
receptacle with a hinged protective cover.
c. 120/240 Volts, 60 Hz Power Output Receptacle.
(2) The inlet receptacle provides for connection
(1) The outlet power receptacle is a five pin
of a source of 120/240 volts, 60 Hz electrical power to
snap lock receptacle with a hinged protective cover.
the shelter electrical system.
(2) The outpower power receptacle provides for
d. Air lock Light Receptacle. The air-lock light
connection of another shelter to the 120/240 volts, 60 Hz
receptacle provides a source of 120 volts, 400 Hz
electrical circuit.
electrical power for connection of the air lock light
d. Air Lock Light Receptacle. The air lock light
assembly.
receptacle provides a source of 120 volts, 400 Hz
Change 1, 2-1
