TB 9-2320-360-13&P-2
LEFT CAB SIDE (REAR) ARMOR REPLACEMENT - CONTINUED
0029 00
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Cab side (rear) armor weighs 240 lb (109 kg).
Thicker panel is on the outside of the thinner panel.
1.
Position outer cab side (rear) armor (3) and inner cab side (rear) armor (41) together and align bolt holes.
2.
Install two stud brackets (42), six washers (43), and new locknuts (44) on cab side (rear) armor (41 and 3).
3.
Install eight washers (37), bolts (38), washers (36), and new locknuts (35). Tighten locknuts to 35 lb-ft (48 Nm).
4.
Install two bolts (39), lifting eyes (31), washers (34), and new locknuts (33). Tighten locknuts to 35 lb-ft (48 Nm).
NOTE
Vehicle shown has one long bracket (32). Some vehicles may have two short brackets.
5.
Install bracket (32), eight bolts (40), washers (45), and new locknuts (46). Tighten locknuts to 35 lb-ft (48 Nm).
0029 00-5
