TB 9-2320-360-13&P-2
RIGHT CAB SIDE (REAR) ARMOR REPLACEMENT - CONTINUED
0028 00
INSTALLATION - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Cab side (rear) armor weighs 240 lb (109 kg).
7.
Attach sling and lifting device to lifting eyes (29).
NOTE
Position top edge of cab side (rear) armor panel below edge of roof.
8.
Using lifting device, install cab side (rear) armor (24) on vehicle.
9.
Install eight washers (26) and new locknuts (25). Tighten locknuts to 23 lb-ft (31 Nm).
10.
Install six washers (28) and new locknuts (27) on cab side (rear) armor (24). Tighten locknuts to 23 lb-ft (31 Nm).
26
26
25
24
29
27,28
417-106
0028 00-6
