TM 9-4931-374-13&P
CONVERSION TABLE
IN.
CM
NOTES
4.500.10
11.430.25
1.
All dimensions shown are in inches. A dimension with a two-digit
0.60
1.52
decimal has a tolerance of 0.13 in. (0.33 cm) and a three-digit
0.922
2.342
decimal has a tolerance of +0.060 in. (0.152 cm). All angles have
51.75
131.45
a tolerance of 5 degrees.
23.00
58.42
7.19
18.26
2.
56.38
143.21
3.
Ream ends to remove rough edge and break all sharp edges.
WARNING
Use only type 1.1.1 trichloroethane solvent. Never use
solvent unless ventilation is provided. Breathing sol-
vent vapors will cause unconsciousness, prolonged skin
contact with solvent will cause irritation, and taking
solvent internally will cause vomiting.
4.
Degrease with type 1.1.1 trichloroethane (item 20, app D).
5.
Apply one coat primer coating (item 15, app D), followed by two
coats white lacquer (item 11, app D).
6.
Do not apply primer or lacquer within 0.60 in. (1.52 cm) of eithe r
end.
E-13