Figure 4-8.TM 55-8115-200-23&Pthreshold plates securedloose, replace nails withto the floor with nails become1/4 inch diameter carriage bolts,square-neck, round-head (NSN 5306-00-057-2506),washer (NSN 5310-00-809-4058), and nut (NSN5310-00-929-1807). Be sure that bolt head does not pro-trude.4-10. Kick P1ate (fig.4-8).a. Insert a flat steel chisel between drivescrew headand kick plate and shear off head.b. Remove damaged kick plate.c. Install new kick plate and install with adhesive.d. Drill 3/16-inch diameter holes through kick plate,plywood and rails so that drivescrews will not use previous-ly drilled holes.e. Using drivescrews3/16-inch diameter with5/16-inch grip, insert and drive screws into rails.Section IV. CONTAINER ROOF4-11. Roof Panel.a. Repair minor roof panel damage as follows:(1) Remove paint from damaged area.(2) Weld the crack or small tear with E6017 elec-trode with 60,000 minimum yield, (item 1, App. D).(3) Paint repaired area in accordance with Specifi-cation MIL-T-704. After cleaning and treating, apply twocoats of olive drab, rust-inhibiting, semi-gloss enamelpaint, (item 2, App. D). Allow overnight drying betweencoats.(4) The use of closed mandrel rivets (not poprivets) in lieu of welding patch is also acceptable providingpatch is watertight. To waterproof patch, caulk area aroundhole, apply patch, drill and rivet patch and then place beadof caulking around the entire periphery of the patch.b. Repair major roof panel damage (containers num-bered less than 12000) as follows:(1) Remove paint from damaged area.(2) Cut the damaged area such that a piece of metalcan be placed over the damaged area (fig. 4-9).4-10Change 4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
