TM 9-4931-374-13&P
Step 2. Check the 120/208V cable assembly for open circuits.
With power source off, disconnect 120/208V cable
assembly and make an ohmmeter check of each phase
through the cable from the socket connector
end to the pin connector end. Repair as required
(p 3-324).
POWER SUPPLY
5. THE POWER SUPPLY DOES NOT OPERATE.
Step 1. Check circuit breaker CB15.
Reset the circuit breaker.
Step 2. Check the circuit breaker on the power supply.
Repair as required; see TM 11-6130-246-12 for the
power supply technical information.
Step 3. With electrical power off, check wire and terminal con-
nections from CB15 to the power supply.
Repair as required (p 3-46).
WORK TABLE ELECTRICAL OUTLETS
6. THERE IS NO ELECTRICAL POWER AT WORK TABLE OUTLETS.
Step 1. Check circuit breakers CB6 and CB8.
Reset circuit breakers.
Step 2. With power off, check electrical connections and wiring
to the outlets (p 3-46).
Repair as required (p 3-224).
3-9
