TM 9-4931-374-13&P
CHAPTER INDEX (cont)
Page
Page
Wire Assembly--(Switchbox)--Maintenance
Sorting File--Maintenance Instructions .................................................
3-322
Instructions ...........................................................................................
3-243
Special Tools, TMDE, and Support Equipment ....................................
3-2
Wire Assembly--Maintenance Instructions ...........................................
3-239
Storage or Shipment ............................................................................
3-348
Wiring Harness Assembly (Bench)--
Switchbox and Mounting Bracket (With Toggle
Maintenance Instructions......................................................................
3-224
Switch)--Maintenance Instructions .......................................................
3-186
Wiring Harness Assembly (Ceiling)--Maintenance
Switchbox and Mounting Bracket (Without Toggle
Instructions ...........................................................................................
3-227
Switch)--Maintenance Instructions .......................................................
3-196
Wiring Harness Assembly (Switchbox to
Troubleshooting Information.................................................................
3-5
Distribution Panel)--
Wire Assembly (Ceiling Outlets)--Maintenance
Maintenance Instructions......................................................................
3-237
Instructions ...........................................................................................
3-234
Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND
SUPPORT EQUIPMENT
No support equipment or TMDE is required for the shop set. Special tools
3-1. COMMON TOOLS AND EQUIPMENT
are listed in appendix C of this manual.
For authorized common tools and equipment refer to SC 4931-95-CL-A21.
3-3. REPAIR PARTS
3-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
Repair parts are listed and illustrated in appendix C of this manual.
Section II. SERVICE UPON RECEIPT
b. A compressed air source must be supplied with a hose capable of
3-4. SITE AND SHELTER REQUIREMENTS
connection to the male quick-disconnect coupling assembly located on the
exterior shelter wall to the left of the personnel door.
a. The ground shall be level and firm enough so that leveling jacks on
the shelter can properly level the shop set.
c. An electrical power source must be furnished to provide 120/208-volt,
3-phase, 60-Hz electrical power to the shelter.
3-2