TM 9-2330-390-14&P5-2.FRONT DRAWBAR BUSHINGS REPLACEMENT.This Task Covers:a. Removalb. CleaningC.installationInitial Setup:Equipment Conditions:Tools/Test Equipment:l Front drawbar removed (see paragraph 4-53).l General mechanic’s tool kit (item 30, Appendix G)l Arbor press (Item 23, Appendix G)Materials/Parts:General Safety Instructions:l Sealing compound (item 8, Appendix F)l Dry cleaning solvent (Item 27, Appendix F)l Dry cleaning solvent is flammable and must not beused near an open flame. Use only in a well-venti-lated area.Press out two bushings (1) from front drawbar (2).Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protectivegoggles and gloves, and use only in a well-ventilated area. Avoid contact with skin,eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame orexcessive heat. The solvent’s flash point is 100°F-138°F (38°C-59°C). If you becomedizzy while using cleaning solvent, Immediately get fresh air and medical help. ifsolvent contacts eyes, immediately wash your eyes and seek medical attention.Clean bushing bores in front drawbar to remove all traces of grease, din, and sealing compound.5-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
