TM 9-2330-390-14&P
4-26. ELECTRICAL REPAIR.
a.
following
General. Specific electrical system maintenance tasks are covered in Section VI of this chapter. The
are general electrical practices and procedures.
b. Identification Band Replacement.
(1) Remove identification band (2) from
wire lead (1) and discard.
(2)
Mark new identification band (2) with
proper identification number.
(3) Position new identification band (2)
on wire lead (1) and bend tabs over wire lead.
c. Terminal Lead Replacement.
(1)
Cut terminal lead (3) off wire lead (4)
and discard.
(2)
Remove insulation from wire lead (4)
equal to depth of new terminal lead (3).
(3)
Position new terminal lead (3) on wire
lead (4) and crimp (Item 29, Appendix G).
d. Male Connector Repair.
(1) Slide back shell (6) and remove
washer (7) from wire lead (5). Cut ferrule (8) from wire
lead and discard. Remove shell.
(2)
Remove insulation from wire lead (5)
equal to depth of new ferrule (8).
(3)
Slide shell (6) on wire lead (5).
(4)
Position new ferrule (8) on wire lead
(5) and crimp (Item 29, Appendix G).
(5)
Position washer (7) on wire lead (5)
near crimping. Slide shell (6) over washer and ferrule (8).
4-14