TM 9-2330-390-14&P2-10.ATTACHING FRONT AND REAR DOLLIES TO EACH OTHER (Con’t).Use extreme caution when using ladder. Have an assistant hold ladder to ensure thatit Is stable. Failure to follow this warning may cause serious Injury to personnel.i.At front and rear dolly top beams (2) remove two detent pins (10) and rotate top hooks (9) 180° awayfrom shelter engagement position. Install detent pins.j.At front dolly, pull down on two lift cylinder levers (3) and then pull down on positioning cylinders lever (4)until top beam (2) contacts and alines with top beam of rear dolly.Use extreme caution when lnstalling twist locks. Keep hands and/or feet clear of tophooks, top and bottom beams, and from between beams. Failure to follow this warningmay cause serious Injury to personnel.k.At front and rear dolly top beams (2) install two twist locks (7). Rotate twist locks 90° so that twist lockpins (8) are horizontal. Tighten nuts (5) with twist lock wrench (Item 3, Appendix D). Install safety pins (8) throughtwistlocks to secure nuts.I. At front dolly, push up on positioning cylinders lever (4) to raise bottom beam (1) 1-2 in. (3-5 cm) off theground.m. At front dolly, push up on two lift cylinder levers (3) to draw in bottom beam (1) as close as possible tobottom beam of rear dolly.n.At front dolly, pull down on positioning cylinders lever (4) to aline holes In bottom beam (1) with holes Inbottom beam of rear dolly.2-69
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business