TM 9-2330-379-14&P
Section III OPERATION UNDER USUAL CONDITIONS
Page
Page
After Use .................................................... 2-40
Operation . ...........................................
2-39
Before Use ................................................. 2-23
Preparation for Use ..............................
2-25
BEFORE USE
Uncoupling Empty Dolly Set from Tow Vehicle
1.
Park the dolly set as close to the shelter as possible.
2.
After tow vehicle has completely stopped, apply parking brake on rear dolly set by placing parking brake lever
(1) to ON position. Brakes are applied automatically when dolly set is disconnected from prime mover.
3
Disconnect the intervehicular electrical cable (front harness) (2) from the tow vehicle and from the electrical
junction box (3) on the front dolly. Coil harness and stow in place on left side of rear dolly adapter.
4
Remove safety chains (4) from tow vehicle and stow them by connecting to eye holes on the end of tow bar
rail.
5.
Disconnect dolly set tow bar lunette (5) from the pintle assembly of the tow vehicle.
6.
Close service and emergency air valves on tow vehicle.
7.
Disconnect service (6) and emergency (7) air hoses from the tow vehicle.
8.
Disconnect the ends of the service (8) and emergency (9) air hoses from the rear dolly.
9.
Coil and stow the air hoses on the tool box until needed for coupling procedures.
2-23
