TM 11-5410-213-14P
INTRODUCTION
1. scope
Code
Definition
X D A support item that is not stocked. When
This manual lists spares and repair parts; special
required, item will be procured through nor-
tools; special test, measurement, and diagnostic
mal supply channels.
equipment (TMDE), and other special support
NOTE
equipment required for performance of operator's,
Cannibalization or salvage may be used
organizational, direct support, and general support
as a source of supply for any items source
maintenance of the S-280A/G and S-280B/G. It
coded above except those coded XA and
authorizes the requisitioning and issue of spares and
aircraft support items as restricted by
repair parts as indicated by the source and main-
AR 700-42.
tenance codes.
(2) Maintenance code. Maintenance codes are
2. General
assigned to indicate the levels of maintenance
This Repair Parts and Special Tools List is divided
authorized to USE and REPAIR support items. The
into the following sections:
maintenance codes are entered in the third and
a. Section II. Repair Parts List. A list of spares
fourth positions of the Uniform SMR Code format
and repair parts authorized for use in the per-
as follows:
formance of maintenance. The list also includes
(a) The maintenance code entered in the third
parts which must be removed for replacement of
position will indicate the lowest maintenance level
the authorized parts. Parts lists are composed of
authorized to remove, replace, and use the support
functional groups in numeric sequence, with the
item. The maintenance code entered in the third
parts in each group listed in figure and item num-
position will indicate one of the following levels of
ber sequence.
maintenance
Application/Explanation
Code
c. Section IV. National Stock Number and Part
OSupport item is removed, replaced, used at the
N u m b e r I n d e x A list, in National item iden-
organizational level.
tification number (NIIN) sequence, of all National
FSupport item is removed, replaced, used at the
stock numbers (NSN) appearing in the listing,
direct support level.
followed by a list, in alphameric sequence, of all part
HSupport item is removed, replaced, used at the
numbers appearing in the listings. National stock
general support level.
numbers and part numbers are cross-referenced to
e a c h illustration figure and item number ap-
(b) The maintenance code entered in the
pearance.
fourth position indicates whether the item is to be
repaired and identifies the lowest maintenance level
3. Explanation of Columns
with the capability to perform complete repair (i.e.,
a. Illustration. This column is divided as follows:
all authorized maintenance functions). This position
(1) Figure number. Indicates the figure number
will contain one of the following maintenance codes:
of the illustration on which the item is shown.
Code
Application/Explanation
(2) Item number. The number used to identify
item called out in the illustration.
F- The lowest maintenance level capable of com-
b. Source, Maintenance, and Recoverability
plete repair of the support item is the direct
(SMR) Codes.
support level.
(1) Source code. Source codes indicate the man-
HThe lowest maintenance level capable of com-
ner of acquiring support items for maintenance,
plete repair of the support item is the general
repair, or overhaul of end items. Source codes are en-
support level.
tered in the first and second positions of the
ZNonreparable. No repair is authorized.
Uniform SMR Code format as follows:
(3) Recoverability code. Recoverability codes
Definition
Code
are assigned to support items to indicate the
disposition action on unserviceable items. The
PAItem procured and stocked for anticipated or
recoverability code is entered in the fifth position of
known usage.
the Uniform SMR Code format as follows:
