TM 10-8340-240-12&P
0014 00-1
MODULAR GENERAL PURPOSE TENT SYSTEM (MGPTS) 0014 00
REPAIR OF HOLES AND TEARS IN FABRIC ASSEMBLES.
THIS SECTION COVERS:
Repair
INITIAL SETUP
Fabric Assembly, End Wall and Mid Module Assembly, Unpacked
Maintenance Level
Materials/Parts:
Unit
Fabric (WP 0030 00)
Tools:
Tentage Repair Kit (WP 0034 00, Item 1)
Equipment Conditions:
Although fabric assemblies can be repaired during operational use of MGPTS when
necessary, it is recommended that fabric be repaired when MGPTS is not in use. Fabric
assemblies should be clean and dry.
a. (See Figure 0014 00-1). Obtain a clean,
round patch (1) from bulk material that is at
least 1 inch larger than the damaged fabric
area (2) in all directions.
b. Place the damaged fabric area (2) on a flat
surface, or place a piece of softwood
under the damaged fabric area (2).
c. Center patch (1) over damaged fabric area
(2). Draw a circle on fabric (2) around patch
(1), then remove patch (1).
d. Clean damaged fabric area (2) inside circle.
The adhesive has a high alcohol content and is highly
flammable. Use only in well ventilated areas away from
open flame. Do not smoke. In case of dizziness, leave
area immediately and allow to ventilate. Failure to
observe this warning may result in injury or death.
This section intentionally left blank
1
2
Figure 0014 00-1
