ARMY TM 10-8340-211-13
AIR FORCE TO 35E5-1-101
4-24. Dual Eave, Corner and Door Guy Lines,
This task covers:
a.
Service
b.
Replace
INITIAL SETUP:
Materials/Parts
Equipment Condition
Guy Lines (Appendix F)
Tent Erected
Soft-Bristled Brush (Item 4, Appendix E)
Soap/Water (Item 3, Appendix E)
a.
Service.
Clean all lines with a solution of mild soap and water applied with a soft-bristled brush. Rinse lines, wipe
dry.
b.
Replace (figure 4-21).
(1)
Obtain proper replacement guy line (1).
(2)
Thread one end through tent slip (FM 10-16), fairlead (2) and through the other end of tent slip.
(3)
Tie an overhand knot (FM 10-16) in one end at tent slip. Make loop similar to a tied eye (FM 10-16) that
will fit over tent pin.
(4)
Position loop over tent pin, then draw tent slip toward pin to tighten. Move tent slip toward eave to loosen.
NOTE
Remove and install all other similar lines as described above.
4-32
