ARMY TM 10-8340-211-13
AIR FORCE TO 35E5-1-101
(5)
Secure liner (8, view E) to doors, corners, and wall eaves (9) of tent (10) by passing eave suspension lines
(11) of liner through hardware eye (12) on inside of tent, then run suspension lines through grommets (13)
in liner (8) and secure to D-rings (14) of liner.
(6)
Tie tapes at sides of liner doors to door eave poles (15, view F).
(7)
Use a ladder for height to wrap and tie liner pole sleeves (16) around center poles.
(8)
Remove tent sidewall footsteps (17) from footstop pins, secure liner sidewall screen and liner sidewall
footsteps (18) to footstop pins, then reinstall tent sidewall footstops to footstop pins.
(9)
Assure that all guy lines (19) are tight and that tent roofs, ends, and sidewalls are free of wrinkles. Adjust
guy line slips accordingly.
i.
Striking and Folding Liner in Large Tent.
(1)
Loosen all guy lines (19, figure 4-11) slightly at slips, remove tent wall footstops (17) from footstop pins,
remove liner sidewall and liner screen footstops (18) from footstop pins, then reinstall tent wall footsteps on
footstop pins.
(2)
Untie all tapes at corner and door eave poles (15), then use a ladder for height and untie tapes of pole
sleeves (16) from center poles.
(3)
Untie and separate liner eave suspension lines (11) from tent body.
(4)
Use a ladder for height, untie ridge suspension lines (7) from ridge D-rings and allow liner to fall on the
ground.
(5)
By moving slips (2), loosen all guy lines enough to allow center poles (6) to be lifted until liner (3) can be
pulled under them to one side of the tent.
(6)
Refer to figure 4-12 and lay liner (1) out as nearly flat as possible, with sidewalls (2) and screens under
liner, eave suspension lines (3) laid on top of liner, and triangular portions of end walls (4) folded back on
roof.
(7)
Fold ends of liner toward center (view B), first with a three and one half foot fold, then three succeeding
folds of six foot each. The folded dimensions of liner at this point are approximately six by eighteen feet.
(8)
Make two folds as shown in view C, two more as shown in view D, then place folded liner on opened cover,
view E.
NOTE
Be sure that folds allow all liner sidewall windows to lay flat in the final three foot dimension.
(9)
Close and secure cover over liner.
4-17