TM 10-8340-205-13&PFigure 2-3. Spreading Tent(4) Open slide fasteners on tent walls and fold side and front walls over roof area of tent.(5) Drive 24-inch (61.000-cm) pins into the ground at locations shown in Figure 2-2.NOTEThe 5-foot, 11 1/4-inch ridge pole for the stack section is over twelve feet from theground and the 11-foot, 10-inch ridge pole for the service section is nine feet fromthe ground.The service section ridge pole must be connected to the front 12-foot, 3-inchupright pole supporting the stack section ridge pole. Additionally, the jumperline located at the inside top of the tent where the front 12-foot, 3-inch uprightjoins the 5-foot, 11 1/4-inch ridge pole must be used to secure the junction ofthe service and stack section ridge poles (See Figure 2-9).The front peak of the service section is approximately nine feet from theground and the screen wall must be attached at this point BEFORE the tent israised.If you do not have access to a ladder or other means to make theseconnections, perform the following steps. If a ladder is available, proceed tostep (13).(6) Assemble ridge poles and uprights flat on the ground as shown in Figure 2-4.2-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
