TM 10-5411-207-24Psupported exceeds density spread indicated in the basis of issue, the total authorization is increasedproportionately.(9)The statement “END OF FIGURE” appears just below the last item description in Column 5 fora given figure in both Section II and Section III.(10) The indenture, shown as dots appearing before the repair part, indicates that the item is a repairpart of the next higher assembly.f.QTY (Column (6)). The QTY (quantity per figure column) indicates the quantity of the item usedin the breakout shown on the illustration figure, which is prepared for a functional group, subfunctional group,or an assembly. A “V” appearing in this column in lieu of a quantity indicates that the quantity is variableand may vary from application to application.4.EXPLANATION OF COLUMNS (SECTION IV).a.NATIONAL STOCK NUMBER (NSN) INDEX.(1) STOCK NUMBER column. This column lists the NSN by National item identificationnumber (NIIN) sequence. The NIIN consists of the last nine digits of the NSN, i.e.NSN5305-01-574-1467NIINWhen using this column to locate an item, ignore the first 4 digits of the NSN. However, the complete NSNshould be use when ordering items by stock number.(2)FIG. column. This column lists the number of the figure where the item is identified/located.The figures are in numerical order in Section II and Section III.(3)ITEM column. The item number identifies the item associated with the figure listed in theadjacent FIG. column. This item is also identified by the NSN listed on the same line.b. PART NUMBER INDEX. Part numbers in this index are listed by part number in ascendingalphanumeric sequence. (i.e., vertical arrangement of letter and number combination which places the firstletter or digit of each group in order A through Z, followed by the numbers 0 through 9 and each followingletter or digit in like order).(1)CAGEC column. The Commercial and Government Entity Code (CAGEC) is a 5-digit numericcode used to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.(2)PART NUMBER column. Indicates the primary number used by the manufacturer (individual.firm. corporation or Government activity), which controls the design and characteristics of the item by meansof its engineering drawings, specifications. standards, and inspection requirements to identify an item or rangeof items.(3)STOCK NUMBER column. This column lists the NSN for the associated part number andmanufacturer identified in the PART NUMBER and CAGEC columns to the left.(4)FIG. column. This column lists the number of the figure where the item is identified/locatedin Sections II and III.(5)ITEM column. The item number is that number assigned to the item as it appears in the figurereferenced in the adjacent figure number column.5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
