TM 10-5411-205-13
4-7.
Delamination Repair (cont).
(3) Drill 3/16 inch diameter pressure release holes no closer than 1/2 inch from
edge of delaminated surface. Number of holes should be determined by size of
delamination area. (Release holes should be approximately 2 inches apart.)
Figure 4-1. Skin Panel Delamination Repair.
WARNING
Gloves are to be worn when mixing and
due to possible skin irritation caused by
tact with the body skin surface.
NOTE
applying adhesive material
adhesive coming into con-
The Versamid material is extremely sensitive to moisture absorp-
tion. Therefore, make sure Versamid 140 container has lid firmly
replaced after material has been removed from shipping or storage
container. Both the Epic R1003 and the Versamid 140 materials
have a shelf life of one year.
(4) Using the outline of the marked delaminated area, mask off the surrounding
area (approximately a width of 2 feet) with kraft wrapping paper or newspaper.
Using unwaxed clean containers, mix thoroughly the Epic Resin and Versamid
material as follows:
(a) Mixing by wieght -- Mix 15 ounces Epic R1003 to 5 ounces of Versamid
140.
(b) By volume -- 2 parts of Epic R1003 to 1 part of Versamid 140.
4-4
