Louver Cover Assembly

TM-10-5411-205-13 Shelter Electrical Equipment S-250/G (Unshielded) (NSN 5411-00-999-4935) (Shielded) (NSN 5411-00-189-6076) Manual
Page Navigation
66

TM 10-5411-205-13 3-28. Louver Cover Assembly. (b) Position new hinge (10) in place on cover assembly (3) and secure with nine rivets (9). (Refer to paragraph 3-9.a for rivet installation instruc- tions.) d . Install. (Figure 3-30) (1) (2) (3) (4) (5) Clean adhesive residue from gasket track in panel cover, and apply RTV 138 silicone sealer in track groove. CAUTION Allow at least 30 minutes cure time for adhere before using louver cover. the silicone sealer to Snap new silicone gasket (6) in track on louver cover panel. Position louver cover assembly (3) in place on inner door assembly (4) and turn four latches onto louver cover to hold cover in place. Dip ten phillips head screws (1) in sealer, position cover shim (5) in place behind cover hinge, and secure with screws (1) and lock washers (2). Apply a continuous bead of sealer on the top mounting edge of cover shim (5) and cover hinge. Figure 3-30. Louver Cover Assembly Replacement. 3-57

Privacy Statement
Press Release
Contact