General Repair Procedures (cont) - TM-10-5411-205-13

General Repair Procedures (cont) - TM-10-5411-205-13_36

General Repair Procedures (cont) - TM-10-5411-205-13_38

TM-10-5411-205-13 Shelter Electrical Equipment S-250/G (Unshielded) (NSN 5411-00-999-4935) (Shielded) (NSN 5411-00-189-6076) Manual
Page Navigation
29

TM 10-5411-205-13 3-9. General Repair Procedures (cont). Table 3-4. Maximum Torque Requirement for Rivnut Screws. Screw Size 4 - 40 6-32 8-32 10-32 1/4 -20 5/16 - 18 3/8 - 16 Torque (lbs/inch) 8 inch lb 12 inch lb 20 inch lb 20 inch lb 50 inch lb 65 inch lb 120 inch lb Figure 3-11. Repair of Turning Rivnut c . Temporary Panel Repair. Any puncture in the shelter exterior, including punctures in the door skin, must be patched immediately to prevent water intrusion. Dents without punctures do not require patching. However, if bare metal is exposed, touch-up paint shall be applied (paragraph 3-9.d). Materials/Parts Adhesive (Item 30, Appendix D) Sealer, Silicone (Item 26, Tape, Polyethylene (Item 29, Appendix D) Appendix D) Clean Cloth, Cotton (Item 10, Sandpaper, Grit Nos. 60 (Item Appendix D) 15, Appendix D) Solvent (Item 9, Appendix D) Gloves (Item 1, Appendix D) 3-20

Privacy Statement
Press Release
Contact