EXPLANATION OF COLUMNS IN THE MAC, SECTION II

MAINTENANCE FUNCTIONS (CONT) - TM-10-5411-203-13_129

EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS, SECTION III - TM-10-5411-203-13_131

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
125

TM 10-5411-203-13 B-3. EXPLANATION OF COLUMNS IN THE MAC, SECTION II a. Column 1, Group Number. Column 1 lists the functional group code numbers, the purpose of which is to identify maintenance significant components, assemblies, subassemblies, and modules with the next higher assembly. End item group number shall be "00." b. Column 2, Component/Assembly. Column 2 contains the names of components, assemblies, subassemblies, and modules for which maintenance is authorized. c. Column 3. Maintenance Functions. Column 3 lists the functions to be performed on the item listed in column 2. (For detailed explanation of these functions, see paragraph B-2.) d. Column 4, Maintenance Category. Column 4 specifies, by the listing of a work-time figure in the appropriate subcolumn(s), the category of maintenance authorized to perform the function listed in column 3. This figure represents the active time required to perform that maintenance function at the indicated category of maintenance. If the number or complexity of the tasks within the listed maintenance function vary at different maintenance categories, appropriate work- time figures will be shown for each category. The work-time figure represents the average time required to restore an item (assembly, subassembly, component, module, end item, or system) to a serviceable condition under typical field operating conditions. This time includes preparation time (including any necessary disassembly/assembly time), troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to perform the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol designations for the various maintenance categories are as follows: C - Operator or Crew O - Unit F - Direct Support H - General Support L - Specialized Repair Activity (SRA) D - Depot e. Column 5. Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual tools) and special tools, TMDE, and support equipment required to perform the designated function. f. Column 6, Remarks. This column shall, when applicable, contain a letter code, in alphabetical order, which shall be keyed to the remarks contained in section IV. B-3

Privacy Statement
Press Release
Contact