TM 10-5411-200-14T.O. 35E4-177-14-40.(cont)CAUTIONSeals shall not be washed with any aromatic hydrocarbon(such as benzene, toluene, or xylene) which will causedeterioration.e.Clean seal with a lint-free cloth by dry wiping prior to bonding.f.Brush sealant (Item 18, Appendix E) on mating surfaces of seal andbonding surface.g.When sealant is tacky (approximately 5 minutes), place seal inposition, press firmly to seat and ensure contact with mating surface.h.If seal is the type that has a retaining strip, seal shall be bondedprior to riveting retaining strip.(Refer to paragraph 4-32 for blind rivetinstallation.)i.After installing rivets, using hand blind riveter, cover rivets andseal with sealing compound (Item 19, Appendix E).4-41.THREADED INSERTS REPLACEMENT.NOTEInserts installed in extrusions are not potted.Forremoval of these inserts, perform steps a and b only.Knock out insert and replace with same type.a.Depending on insert size, select a drill bit in size range listedbelow.Insert Thread SizeDrill Size Rangeinches (mm)10-327/16-15/32 (11/12.4)1/4-2817/32-21/32 (13.5/16/7)5/16-2439/64-21/32 (15.5/16.7)3/8-2443/64-23/32 (17/18.3)4-175
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
