TM 10-5411-200-14
T.O. 35E4-177-1
4-24.
(cont)
7.
Position handle (5) in support (6) and on jack screw (19) with holes
in handle yoke and jack screw aligned. Install pins (3 and 4).
8.
Install spring plunger (2) in handle yoke and secure with nut (l).
Adjust nut to control handle movement.
9.
Position basic jack on base (18) with spacers (17) and secure with
pin (16), washer (15), and new cotter pin (14).
10.
Install grease fitting (7) and lubricate jack with grease.
4-25.
PERSONNEL DOOR END ENDWALL PANEL REPLACEMENT AND REPAIR
This task covers:
a. Removal
d.
Repair
b.
Disassembly
e. Assembly
c. Cleaning, Inspection
f.
Installation
INITIAL SETUP
Special Tools
Materials
Hand blind riveter, Appendix B, Item 2
Adhesive, Item 2, Appendix E
Personnel - 4
Standard tools
1 Electrician
General mechanics tool kit
REMOVAL
Personnel Door End Endwall Panel
1.
Set main circuit breaker to OFF position.
2.
Disconnect service entry power at power entry panel and remove
components. (Refer to paragraph 5-3)
3.
Remove door activated blackout switch and associated wiring.
(Refer
to paragraph 4-15)
4.
Remove area light assembly.
(Refer to paragraph 3-4)
5.
Remove hinged endwalls adjacent to personnel door end panel endwall
in accordance with paragraph 4-21.
4-119
