TM 10-5410-229-13&P
G-2. OPERATING INSTRUCTIONS - Cont’d
(e)
From outside the MPCS overlap the M577 bootwall at the corners of each outside wall (1) by lining up the
corresponding side strips of hook and pile fastener (2) and pressing together.
(f)
Fasten the row of quick disconnect fasteners (3) on the inside corners of each wall. Draw the buckle straps (4) tight.
(g)
Fasten the quick disconnect fasteners (3) on the outside of the wall corners and draw the buckle straps (4) tight.
(e)
Each corner of the roof cap (7) has flaps (8) that must overlap the corresponding wall juncture. Pull the outside roof
cap corner flaps (8) down and press the hook and pile fasteners (9). Make sure the strips are pressed tight, so that
rainwater will stay out and interior light cannot escape.
(f)
Loosen the bolts (10) that attach the hold-down track (11) along the top rear of the M577 (12).
(g)
If antenna (13) is present, place the sleeve (14) over the antenna cylinder.
(h)
Push the hem (15) along the top forward edge of the bootwall under the track (11), making sure the hem (15) is
centered on the M577, then tighten the track (11).
(i)
From inside the M577 bootwall, loosen the wing nuts (16) securing the tracks (17) along the right and left rear sides
of the M577. Place the hems (15) under the tracks (17) and tighten.
(j)
Attach the straps (18) on the reinforcement panel (19) on the top of the M577 bootwall (20) to the corresponding
loops (21) on the top of the M577 (12) and tighten the straps (18).
(k)
If antenna is present, tighten the sleeve (14) around the antenna cylinder (13) using the draw string (22).
(1)
Attach the right (23) and left (24) halves of the blackout skirt to the underside of the M577 by attaching the straps
(25) to the loops (26) on the
G-9
