TM 10-5410-229-13&P
1-10.
LOCATION AND DESCRIPTION OF MAJOR PARTS - Cont’d.
(1)
Plain Wall Liner. The plain wall liner (1) is constructed of a lightweight, pajama check weave cloth and is
approximately 12’ wide x 7 high. On the inside, eight quick release male fasteners are located approximately 18" apart
along the top edge. Seven buckle assemblies with quick release female fasteners are located approximately 12" apart
and 22" from the edge along each side, with three more located approximately 5’apart and 12" above the bottom edge. An
identification label is sewn to the inside. In addition, seven side straps with quick release male fasteners are located
approximately 12" apart along the outer edge of each side. On the outside, a 2" strip of pile fastener is sewn along the
upper seam of the liner. The plain wall liner provides insulation and can be used as outside wall in hot weather during
daylight hours. The liner also assists in providing light discipline. One plain wall liner is issued with each MCPS.
(2)
Plain Wall. The plain wall (2) is constructed of mildew and flame resistant polyester duck cloth and is
approximately 12’6" wide x 8’ high. On the inside, eight quick release male fasteners are located approximately 18" apart
along the top edge. Four female quick release fasteners are also located along the top, spaced about 40" apart. Seven
buckle assemblies with quick release female fasteners are located approximately 12" apart and 22" from the edge along
each side, with three more approximately 5’ apart and 24" above the bottom edge. A 2" wide hook fastener strip is located
along the top, the upper corners, and the outer edge of the right side. An identification label is sewn to the inside of the
wall. On the outside, four roll up straps are located approximately 40" apart along the top and seven small buckle
assemblies with quick release female fasteners are located approximately 12" apart and 22" from the edge along the right
side. In addition, seven side straps with quick release male fasteners are located about 12" apart along the outer edge of
each side. A 2" wide pile fastener strip is located along the top, the upper corners, and the fold line of the right side. One
plain wall is issued with each MCPS.
(3)
Window Wall. The window wall (3) is constructed similar to the plain wall except that it contains a 38" x 38"
clear plastic window, a nylon webbing screen, and a window flap. The screen is sewn into the window opening. The
window is sewn to the bottom seam of the window opening and 1" wide pile fastener strips are located around its outer
edges. A 1" wide hook fastener strip is located around the inside seams of the window opening. On the outside, a window
flap with 1" wide pile fastener strips along its inside edge is sewn to the upper window seam.
1-5
