SECTION I. INTRODUCTION
Note. Common hardware items known to be
1. Scope
readily available in Army supply channels are assigned
Maintenance codes only. Source codes, recoverability
This manual lists repair parts, special tools, test and
codes, and maintenance allowances are not assigned
support equipment required for the performance of
this category.
organizational, direct support, general support
maintenance of the expandable shelter.
a. Source, Maintenance,
and Recover-ability
Codes (SMR).
2. General
(1) Source code.
Indicates the selection
This Repair Parts and Special Tools List is divided into
status and source for the listed item Source codes used
are:
the following sections:
Code
Explanation
a. Prescribed Load Allowance (PLA)-Section II. A
P
Applied to repair parts which are stocked in or
composite listing of repair parts, special tools, test and
supplied from DSA/GSA or Army supply system,
support equipment having quantitative allowances for
and authorized for use at indicated maintenance
initial stockage at the organizational level.
categories.
P2 Applies to repair parts which are procured and
b. Repair Parts-Section III. A list of repair parts
authorized for the performance of maintenance at the
combat or military essentially of the end item
organizational level in figure and item number
dictates that a minimum quantity be available in
sequence.
the supply system.
M
Applied to repair parts which are not procure(d or
c. Special Tools, Test and Support Equipment -
stocked but are to he manufactured at indicated
Section IV. A list of special tools, test and support
maintenance categories.
equipment authorized for the performance of
A
Applied to assemblies which are not procured or
maintenance at the organizational level.
"NOT
stocked as such but are made tip of two or more
APPLICABLE"
units, each of which carry individual stock
numbers and descriptions and are procurer and
d. Repair Parts--Section V. A list of repair parts
stocked and can be assembled by units at
authorized for the performance of maintenance at the
indicated maintenance categories.
direct support, general support level in figure and item
X
Applied to parts and assemblies which are not
number sequence.
procured or stocked; the mortality of which
e. Special Tools, Test and Support Equipment -
normally below that of the applicable end item;
Section VI. A list of special tools, test and support
and the failure of which should
result in
retirement of the end item from the supply
equipment authorized for the performance of
system.
maintenance at the direct support, general support level.
X1
Applied to repair parts which are not procured or
"NOT APPLICABLE"
stocked, the requirement for which will be supplied
f. Federal Stock Number and Reference Number
by use of the next higher assembly or component.
Index-Section VII. A list of Federal stock numbers in
X2
Applied to repair parts which are not stocked. The
indicated maintenance category requiring. such
ascending numerical sequence, followed by a list of
repair parts will attempt to obtain them through
reference numbers appearing in all of the listings, in
cannibalization. Where such repair parts are not
ascending alpha-numeric sequence, cross-referenced to
obtainable through cannibalization, requirements
the illustration figure number and item number.
will be requisitioned with accompanying
Note. Items not illustrated are cross-referenced to
group number.
C
Applied to repair parts authorized for local
procurement.
If not obtainable from local
l)procurement, such repair parts will be
3. Explanation of Columns
requisitioned through normal supply channels with
The following provides an explanation of columns in the
a supporting statement of nonavailability from
tabular lists in Sections II through VI.
local procurement.
G
Applied to major assemblies that are procured
with PEMA (Procurement Equipment Missiles
Army) funds for initial issue only to be used as
exchange assemblies at DSU
and GSU
maintenance level. These assemblies will not be
stocked above DSU and GSU level or returned to
depot level.
iii